Flowmeter Calibration - TRIAL Version

About: Flowmeter Calibration - TRIAL Version

"Flowmeter calibration" is an App that allows to calculate in a simple and practical way the test parameters resulting from the calibration of liquid flowmeters not subjected to pressure using a reference volumetric prover.

This App is ideal for Metrological Institutes and Fuel Storage and Distribution Plants, where it is required to verify that the flowmeters are dispensing the fuel with an error within the limits allowed by law.

The admitted data can be in both the SI (International System of Units) and the English System




The data required for the calculation are:

- API or Fuel density; If the API is used, the calculation will be made based on table 6B and if density is used, table 54B will be used
- αv; Thermic dilatation coefficient of the volumetric prover
- T1, T2, T3; Thermometers of the volumetric prover
- Vp; Volume indicated by the volumetric prover
- Vf; Volume dispatched by the flowmeter

The results that are calculated are:

T = Average temperature of the volumetric prover
CTL = Correction factor for the effect of temperature on liquid
CTS = Correction factor for the effect of temperature on steel, also called VCF
Vpc = Volume corrected of the volumetric prover
E, E% = Error and percentage error


In the TRIAL version you have the following restrictions:

- The App can only be run 60 times
- API greater than 32 is not supported
- Densities under 0.85 are not allowed
- You can only save one result
- The results can not be shared

To eliminate these restrictions, get the PREMIUM version.